Separation Enamel

Separation Enamel

Details

Level: Intermediate        Sessions: 1        Hours: 3 hours

Project Overview

Learn to create a new effect in enamel. Through a series of firing layers of transparent enamels, students will learn how to create this unique process of separation enamel. Students should have a basic understanding of torch fired enameling. (A variety of enamel colors will be provided to share.)
 

Tools

  • Bench Block (steel or anodized aluminum) - Used as a hammering surface for metal stamping or working with metal. 

  • Bezel Shears – Used to cut metal sheet. There are many available on the market, any of which will work, however they should NOT be serrated. (Tin snips or airplane shears will also work, however, they may be large and cumbersome.) If the project has curves in the design and you own a pair, bring curved bezel shears. This is an optional item for most classes. Shears will be provided for use during classes.  

  • Center punch – Used to create a dimple in metal to start a hole for drilling. Also used for riveting. Provided by instructor for all classes

  • Optional Enamel Kit

    Items in this Enamel Kit including enamels will be provided for use during the class. If you are interested in ordering a kit please click on the image. 

    Enamel kit includes: trivet, sifter, penny brite, alundum stone, choice of one color kit, and holding agent. 

  • Tool Hand Tools

    Basic hand tools – Any quality is appropriate for my classes. These do not need to be high end or expense.

    • Round nose - Typically it is preferred that the round nose be a fine tip. Especially for classes with detailed wire work.
    • Chain/needle nose – Tapered jaws for general metal and wire work. Non-serrated are requested for all of my classes. Typically requested for classes to be used for opening and closing jump rings; in which case, 2 pairs are requested or a combination of chain nose and flat nose is suitable.
    • Flat nose – Similar to chain nose but the jaws are not tapered. Non-serrated are requested for all of my classes. 
  • Tool Magazine pages

    Magazine pages of any kind – Take your pick. Or just grab one of the programs at the show. 

  • Tool Magnifier or Optivisor

    Magnifier or Optivisor – For almost all classes this is listed as an “As Needed” tool. If you have sight challenges it is recommended that you are properly prepared. For advance stone setting classes this is required! If you decide to use reading glasses consider better than 2.5x. 

     

  • Tool Paint Brush

    #2 Paint Brush – Any small paint brush will work for these projects. A #2 brush was designated just to demonstrate that it needs to be small. Don’t bring a house painting brush! Just saying. This brush does not need to be expensive, a cheap disposable one will work.

     

                  IF a #2 flat brush is designated, again just looking for a smaller sized brush. 

  • Rawhide/Leather Mallet – Shape and flatten metal without marring it. #2 mallet is a standard size. Instructor will provide for every class needed. A yellow nylon mallet may be used in its place, however a rubber one may not.

  • Student Files – Standard size is 2/o. For filing metal. . Instructor will provide to share for every class needed. 

  • Wood dap set – Used to dap metal to create a convex/concave shape in metal.