Riveting Rings

Riveting Beads

Details

Level: Intermediate        Sessions: 1        Hours: 3 hours

Project Overview

Transform treasured beads into statement rings. In this class, you will learn to set beads onto a ring shank by riveting. Beads will vary.

 
Tools

  • Bench Block (steel or anodized aluminum) - Used as a hammering surface for metal stamping or working with metal. 

  • Tool Flex Shaft

    Flex Shaft – Rotary tool used for polishing, drilling, finishing, etc. Flex shafts are available for purchase new and gently used at the class. Pleased contact the instructor if are interested in purchasing one at the class as quantities are limited. 

  • Tool Hand Tools

    Basic hand tools – Any quality is appropriate for my classes. These do not need to be high end or expense.

    • Round nose - Typically it is preferred that the round nose be a fine tip. Especially for classes with detailed wire work.
    • Chain/needle nose – Tapered jaws for general metal and wire work. Non-serrated are requested for all of my classes. Typically requested for classes to be used for opening and closing jump rings; in which case, 2 pairs are requested or a combination of chain nose and flat nose is suitable.
    • Flat nose – Similar to chain nose but the jaws are not tapered. Non-serrated are requested for all of my classes. 
  • Tool Magnifier or Optivisor

    Magnifier or Optivisor – For almost all classes this is listed as an “As Needed” tool. If you have sight challenges it is recommended that you are properly prepared. For advance stone setting classes this is required! If you decide to use reading glasses consider better than 2.5x. 

     

  • Tool Ott Light

    Ott Light or Task Lamp - This is optional item that is listed for every class. It is up to you to determine whether or not you will need to have one depending on your vision. 

  • Rawhide/Leather Mallet – Shape and flatten metal without marring it. #2 mallet is a standard size. Instructor will provide for every class needed. A yellow nylon mallet may be used in its place, however a rubber one may not.

  • Tool Ring Sizers

    Ring Sizer – Optional, used to measure your ring size. Several sets will be provided to share in class.

  • Riveting Hammer (Swiss Hammer) – Best hammer for riveting due to its small size. Instructor will provide for every class needed. 

  • Self Tapping Center punch – this center punch has a spring action which propels the punch to create a dimple. Classes requiring this tool is specific. The reason for this tool vs. a manual punch is that it does not require the use of a hammer to create the dimple.

     

  • Side Cutters - Also known as wire cutters or snippers.

    For many of my classes I prefer Ultra Flush side cutters because it eases the workload. Ultra flush is the most flush you can buy as opposed to just flush cutters. If you don't own a pair of Ultra Flush cutters, you may want to invest in a good pair either Lindstrom or Swanstrom. There is usually not a different in price between ultra and just flush cutters so why not just buy the best?

    The image shows just a side cutter (top) and ultra flush (bottom).

     

  • Ring Mandrel, Steel – Used for shaping and forming metal into rings. A plastic one will not work in its place. Instructor will provide to share (1 for every 2 people) for every class needed. 

  • Student Files – Standard size is 2/o. For filing metal. . Instructor will provide to share for every class needed.