The Essential Pendant

The Essential Pendant

Details

Level: Beginner        Sessions: 1        Hours: 3 hours

Project Overview

Create your own personal essential oil diffuser to take wherever you go. You will learn to saw, solder and shape sterling silver to create a diffuser you can fill with your favorite oils.

Tools

  • Bench pin – There are a variety of bench pins available on the market, any will do. However, you will need to bring a 4” or larger C-clamp. As the C-clamp provided with a bench pin does not fit most tables at the shows. (Note that if you are attending Bead and Button or Beadfest shows, C-clamps will be provided.)

  • Tool C-clamp

    C-clamp – to be used with bench pins to clamp to tables. May be found at any local hardware store. 

  • Tool Disc Cutter

    Disc Cutter – Used to punch discs out of metals. One set will be provided to share in every class. 

  • Tool Hand Tools

    Basic hand tools – Any quality is appropriate for my classes. These do not need to be high end or expense.

    • Round nose - Typically it is preferred that the round nose be a fine tip. Especially for classes with detailed wire work.
    • Chain/needle nose – Tapered jaws for general metal and wire work. Non-serrated are requested for all of my classes. Typically requested for classes to be used for opening and closing jump rings; in which case, 2 pairs are requested or a combination of chain nose and flat nose is suitable.
    • Flat nose – Similar to chain nose but the jaws are not tapered. Non-serrated are requested for all of my classes. 
  • Helping Hand/Third Hand – Used to hold small parts in place while soldering. Instructor will provide to share for every class needed.

  • Jeweler’s Saw – Used for cutting sheet metal and metal tubes. Instructor will provide for every class needed. 

  • Tool Magnifier or Optivisor

    Magnifier or Optivisor – For almost all classes this is listed as an “As Needed” tool. If you have sight challenges it is recommended that you are properly prepared. For advance stone setting classes this is required! If you decide to use reading glasses consider better than 2.5x. 

     

  • Nylon nose pliers – Flat nose pliers with PVC grips o the heads. Mostly used for straightening wire. In my classes they are used to prevent marring when bending metal. Only required for some classes, but this is mostly an optional item. 

  • Tool Ott Light

    Ott Light or Task Lamp - This is optional item that is listed for every class. It is up to you to determine whether or not you will need to have one depending on your vision. 

  • Rawhide/Leather Mallet – Shape and flatten metal without marring it. #2 mallet is a standard size. Instructor will provide for every class needed. A yellow nylon mallet may be used in its place, however a rubber one may not.

  • Student Files – Standard size is 2/o. For filing metal. . Instructor will provide to share for every class needed. 

  • Wood dap set – Used to dap metal to create a convex/concave shape in metal.