Mobius Pendant

Mobius Pendant

Details

Level: Intermediate        Sessions: 1        Hours: 4 hours

Project Overview

Tired of the same old thing? Take a turn in your silver to create this classic yet modern pendant. You will learn the secret to transforming sterling silver sheet into a graceful moving form. In this class, you will polish your sawing, soldering and finishing skills. Students should have some soldering and sawing experience. Students will complete the pendant, but will want to refine it at home.

 
Tools

  • Bench Block (steel or anodized aluminum) - Used as a hammering surface for metal stamping or working with metal. 

  • Bezel Shears – Used to cut metal sheet. There are many available on the market, any of which will work, however they should NOT be serrated. (Tin snips or airplane shears will also work, however, they may be large and cumbersome.) If the project has curves in the design and you own a pair, bring curved bezel shears. This is an optional item for most classes. Shears will be provided for use during classes.  

  • Tool Hand Tools

    Basic hand tools – Any quality is appropriate for my classes. These do not need to be high end or expense.

    • Round nose - Typically it is preferred that the round nose be a fine tip. Especially for classes with detailed wire work.
    • Chain/needle nose – Tapered jaws for general metal and wire work. Non-serrated are requested for all of my classes. Typically requested for classes to be used for opening and closing jump rings; in which case, 2 pairs are requested or a combination of chain nose and flat nose is suitable.
    • Flat nose – Similar to chain nose but the jaws are not tapered. Non-serrated are requested for all of my classes. 
  • Tool Magnifier or Optivisor

    Magnifier or Optivisor – For almost all classes this is listed as an “As Needed” tool. If you have sight challenges it is recommended that you are properly prepared. For advance stone setting classes this is required! If you decide to use reading glasses consider better than 2.5x. 

     

  • Needle File Set – Used for filing smaller pieces of metal and tight places. When required, either diamond coated or fine tooth is preferred. Some students may prefer to use smaller files as opposed to the student files for their projects.

  • Rawhide/Leather Mallet – Shape and flatten metal without marring it. #2 mallet is a standard size. Instructor will provide for every class needed. A yellow nylon mallet may be used in its place, however a rubber one may not.

  • Student Files – Standard size is 2/o. For filing metal. . Instructor will provide to share for every class needed. 

  • Super Grip Gloves – Optional for all classes, but most have found these very helpful for drilling class and classes that require a lot filing sanding. Not only will they protect your hands, but the grip will allow you to hold onto the stones you are working with. 

     

  • Two-hole draw down punch – This is different from a hand punch as it has 2 sizes in one tool. Instructor will provide to share (1 for every 2 people) for every class needed.